After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy
Use tweezers to handle springs and wire clips. "That'll keep them from flying all over the place and maybe getting lost."
Freshwater reels are for use around inland lakes streams and rivers while saltwater reels are for large bodies of water including oceans and bays. Reels come in three basic styles: casting spinning and fly fishing. Whether you′re after a largemouth bass or a wiley trout
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last
Each reel is a little bit different but the basics are the same. Here are the elementary steps the Kilpatricks recommend to keep your reel working properly.
Take your reel apart properly. "When you take your reel apart lay out the parts on a mat of some sort. Put a strip of masking tape under the line of parts and number each part as you remove it from the reel. That way
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per
Assemble the proper cleaning supplies. "We recommend a pan of hot water Simple Green cleaning compound Ronsonol Lighter Fluid TG's Rocket Fuel Hi-Speed Reel Oil Reel X and Super Lube Grease."
After cleaning wipe the reel down with a rag soaked with a protective coating like Aluma Guard Reel magic or WD-40. A light coating of liquid furniture polish will also work. Be careful to avoid contact with the line or handle grips.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.