After cleaning wipe the reel down with a rag soaked with a protective coating like Aluma Guard Reel magic or WD-40. A light coating of liquid furniture polish will also work. Be careful to avoid contact with the line or handle grips.
After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending
When you′re on a hot bite or a long-planned trip the worst thing that could happen is tackle failure. Losing a great catch due to something that could have been prevented is annoying. Avoid that problem by maintaining and regularly servicing your spinning reels and
When each reel is dry lightly lubricate easily accessible moving parts. This is especially important if the reel was used in saltwater or in dirty or muddy conditions. Do not use the reel until it is fully clean as dirt and sand can cause damage.
It′s not unusual to see their tackle banging around in the back of a pickup going down a dusty road or stored in a boat locker without being washed after a day fishing in saltwater. I often see reels spooled improperly drags set incorrectly and
Lubrication is an essential part of spinning reel maintenance. Use the oil that came with the reel or a quality after-market brand. Ball bearings and metal bushings tend to collect water and salt leading to corrosion and seizure if not oiled. It′s difficult to crank
After a day of fishing rinse each of your reels with fresh water and allow to dry. Don′t use a spray nozzle to do this however. High-pressure water can force sand dirt and salt into the reel. Use light pressure straight from the hose.
Clean parts with Simple Green. "Never use gasoline or similar products to remove dirt and grease from your reel's parts. It'll melt plastics. Use a biodegradable product such as Simple Green and a toothbrush that won't hurt the plastic or fiber parts of the reel."
Grease gears. "Apply grease to the bottom of the teeth not the top. Applying grease to the tops of the teeth will cause the gears to throw the grease everywhere. You want it in the bottom. Also don't slop the grease all over the place;
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.