After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels
Clean parts with Simple Green. "Never use gasoline or similar products to remove dirt and grease from your reel's parts. It'll melt plastics. Use a biodegradable product such as Simple Green and a toothbrush that won't hurt the plastic or fiber parts of the reel."
Grease gears. "Apply grease to the bottom of the teeth not the top. Applying grease to the tops of the teeth will cause the gears to throw the grease everywhere. You want it in the bottom. Also don't slop the grease all over the place;
Before rinsing tighten down the drags especially on spinning reels. This will help keep water from seeping inside. Hold spinning reels upside down with the drag toward the ground when rinsing giving water even less of an opportunity to get inside the reel.
Egg Carton Parts Holder. If you′re the handyman type who can dismantle your own reel for maintenance here′s a tip you can use. Save an empty egg carton or three and number each compartment. Then when as you′re taking your reel apart place each part
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per
There are three types of drag systems : 1. Spring and pawl or “click and pawl” systems feature a spring that pushes the prawl into a gear on the reel spool to produce a drag. Spring and pawl is best for light fishing when targeting
Remove or secure your fishing line before you remove the spool. "Either strip all the line off the spool or secure it with masking tape before you remove the spool from the reel. If you don't the line will get caught between the spool and
Line Replacement. When should you replace old line with new? There′s no set answer to that question but certainly you′ll want to replace it after any long taxing encounter with a hard-fighting fish which can compromise the properties of the line. I also replace mine
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.