Baitcasting Reels: These reels work with the weight of your bait or lure as it pulls on the line and turns the spool. They are typically preferred by more experienced anglers especially when using heavier lures and lines for large game fish. Handles are usually
Grease gears. "Apply grease to the bottom of the teeth not the top. Applying grease to the tops of the teeth will cause the gears to throw the grease everywhere. You want it in the bottom. Also don't slop the grease all over the place;
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per
Never put metal against metal. "Never put metal to metal when working on your reel. All reel parts are designed metal to fiber. Remember that."
After cleaning wipe the reel down with a rag soaked with a protective coating like Aluma Guard Reel magic or WD-40. A light coating of liquid furniture polish will also work. Be careful to avoid contact with the line or handle grips.
Some of my fishing buddies like me have invested a lot of money in the fishing reels they own. With few exceptions though these guys rarely treat their reels like the expensive finely tuned pieces of equipment they are.
Take your reel apart properly. "When you take your reel apart lay out the parts on a mat of some sort. Put a strip of masking tape under the line of parts and number each part as you remove it from the reel. That way
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels
Degrease Stiff Reels. If you purchased a new fishing reel and found it a little stiff when casting take it apart and see if you need to remove some of the grease on the gears. Old reels work better too if you clean out gummed-up
After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.