Spincast Reels: With these reels the line comes off the top of the spool while casting. The spool which runs parallel with the rod remains enclosed by a cover that features a port where the end of your fishing line exits the reel. The spool
Take your reel apart properly. "When you take your reel apart lay out the parts on a mat of some sort. Put a strip of masking tape under the line of parts and number each part as you remove it from the reel. That way
Clean parts with Simple Green. "Never use gasoline or similar products to remove dirt and grease from your reel's parts. It'll melt plastics. Use a biodegradable product such as Simple Green and a toothbrush that won't hurt the plastic or fiber parts of the reel."
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per
Egg Carton Parts Holder. If you′re the handyman type who can dismantle your own reel for maintenance here′s a tip you can use. Save an empty egg carton or three and number each compartment. Then when as you′re taking your reel apart place each part
Grease gears. "Apply grease to the bottom of the teeth not the top. Applying grease to the tops of the teeth will cause the gears to throw the grease everywhere. You want it in the bottom. Also don't slop the grease all over the place;
After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending
Assemble the proper cleaning supplies. "We recommend a pan of hot water Simple Green cleaning compound Ronsonol Lighter Fluid TG's Rocket Fuel Hi-Speed Reel Oil Reel X and Super Lube Grease."
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last
Degrease Stiff Reels. If you purchased a new fishing reel and found it a little stiff when casting take it apart and see if you need to remove some of the grease on the gears. Old reels work better too if you clean out gummed-up
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.