If you′ll be stowing your rods and reels for a couple of months – in winter for example – strip the line and leave it off until just prior to your first trip of the new season. That way you′ll know you are starting with
Degrease Stiff Reels. If you purchased a new fishing reel and found it a little stiff when casting take it apart and see if you need to remove some of the grease on the gears. Old reels work better too if you clean out gummed-up
Before rinsing tighten down the drags especially on spinning reels. This will help keep water from seeping inside. Hold spinning reels upside down with the drag toward the ground when rinsing giving water even less of an opportunity to get inside the reel.
Each reel is a little bit different but the basics are the same. Here are the elementary steps the Kilpatricks recommend to keep your reel working properly.
Hold your reel properly while disassembling and assembling it. "We recommend anglers hold the reel in their left hand and work with their right. That way everything stays oriented. But the really important thing is to always hold it the same. That way the parts
Baitcasting Reels: These reels work with the weight of your bait or lure as it pulls on the line and turns the spool. They are typically preferred by more experienced anglers especially when using heavier lures and lines for large game fish. Handles are usually
After a day of fishing rinse each of your reels with fresh water and allow to dry. Don′t use a spray nozzle to do this however. High-pressure water can force sand dirt and salt into the reel. Use light pressure straight from the hose.
Proper Brake Adjustment Equals Fewer Backlashes. You′ll make more accurate casts with fewer backlashes if you adjust your baitcasting reel′s mechanical brake according to the weight of the lure you′re casting. Look for the brake adjustment knob on the side-plate beneath the handle. With the
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last
It′s not unusual to see their tackle banging around in the back of a pickup going down a dusty road or stored in a boat locker without being washed after a day fishing in saltwater. I often see reels spooled improperly drags set incorrectly and
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.