Fill Your Reel Just Right. When using a baitcasting reel filling the spool to 90 percent capacity is recommended. This optimizes casting performance. Too much line is likely to increase the chance of backlash while not enough limits casting distance. For spinning reels a good
Lubrication is an essential part of spinning reel maintenance. Use the oil that came with the reel or a quality after-market brand. Ball bearings and metal bushings tend to collect water and salt leading to corrosion and seizure if not oiled. It′s difficult to crank
When each reel is dry lightly lubricate easily accessible moving parts. This is especially important if the reel was used in saltwater or in dirty or muddy conditions. Do not use the reel until it is fully clean as dirt and sand can cause damage.
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last
After a day of fishing rinse each of your reels with fresh water and allow to dry. Don′t use a spray nozzle to do this however. High-pressure water can force sand dirt and salt into the reel. Use light pressure straight from the hose.
Proper Brake Adjustment Equals Fewer Backlashes. You′ll make more accurate casts with fewer backlashes if you adjust your baitcasting reel′s mechanical brake according to the weight of the lure you′re casting. Look for the brake adjustment knob on the side-plate beneath the handle. With the
Before rinsing tighten down the drags especially on spinning reels. This will help keep water from seeping inside. Hold spinning reels upside down with the drag toward the ground when rinsing giving water even less of an opportunity to get inside the reel.
Grease gears. "Apply grease to the bottom of the teeth not the top. Applying grease to the tops of the teeth will cause the gears to throw the grease everywhere. You want it in the bottom. Also don't slop the grease all over the place;
Assemble the proper tools before you begin. "You'll need two small screwdrivers — a slot head and a Phillips — along with a pair of tweezers and an old toothbrush. If you have the wrench and parts list that came with your reel keep them
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 simontonauto. All Rights Reserved.