Before rinsing tighten down the drags especially on spinning reels. This will help keep water from seeping inside. Hold spinning reels upside down with the drag toward the ground when rinsing giving water even less of an opportunity to get inside the reel.
To keep reels in prime fighting condition periodic disassembly and cleaning is necessary at least every two years preferably annually. Because of the intricate mechanics this chore is best left to professional technicians at reputable tackle shops or service centers. The reels will be completely
Assemble the proper tools before you begin. "You'll need two small screwdrivers — a slot head and a Phillips — along with a pair of tweezers and an old toothbrush. If you have the wrench and parts list that came with your reel keep them
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy
Fill Your Reel Just Right. When using a baitcasting reel filling the spool to 90 percent capacity is recommended. This optimizes casting performance. Too much line is likely to increase the chance of backlash while not enough limits casting distance. For spinning reels a good
Spincast Reels: With these reels the line comes off the top of the spool while casting. The spool which runs parallel with the rod remains enclosed by a cover that features a port where the end of your fishing line exits the reel. The spool
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last
It′s not unusual to see their tackle banging around in the back of a pickup going down a dusty road or stored in a boat locker without being washed after a day fishing in saltwater. I often see reels spooled improperly drags set incorrectly and
There are three types of drag systems : 1. Spring and pawl or “click and pawl” systems feature a spring that pushes the prawl into a gear on the reel spool to produce a drag. Spring and pawl is best for light fishing when targeting
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2019 simontonauto. All Rights Reserved.