When you′re on a hot bite or a long-planned trip the worst thing that could happen is tackle failure. Losing a great catch due to something that could have been prevented is annoying. Avoid that problem by maintaining and regularly servicing your spinning reels and
After cleaning wipe the reel down with a rag soaked with a protective coating like Aluma Guard Reel magic or WD-40. A light coating of liquid furniture polish will also work. Be careful to avoid contact with the line or handle grips.
Degrease Stiff Reels. If you purchased a new fishing reel and found it a little stiff when casting take it apart and see if you need to remove some of the grease on the gears. Old reels work better too if you clean out gummed-up
Each reel is a little bit different but the basics are the same. Here are the elementary steps the Kilpatricks recommend to keep your reel working properly.
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per
Line Replacement. When should you replace old line with new? There′s no set answer to that question but certainly you′ll want to replace it after any long taxing encounter with a hard-fighting fish which can compromise the properties of the line. I also replace mine
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels
After a day of fishing rinse each of your reels with fresh water and allow to dry. Don′t use a spray nozzle to do this however. High-pressure water can force sand dirt and salt into the reel. Use light pressure straight from the hose.
Assemble the proper tools before you begin. "You'll need two small screwdrivers — a slot head and a Phillips — along with a pair of tweezers and an old toothbrush. If you have the wrench and parts list that came with your reel keep them
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.