Before rinsing tighten down the drags especially on spinning reels. This will help keep water from seeping inside. Hold spinning reels upside down with the drag toward the ground when rinsing giving water even less of an opportunity to get inside the reel.
Fill Your Reel Just Right. When using a baitcasting reel filling the spool to 90 percent capacity is recommended. This optimizes casting performance. Too much line is likely to increase the chance of backlash while not enough limits casting distance. For spinning reels a good
It′s really not difficult or time-consuming to give your reels the TLC they need to perform well every time you go fishing. Nor is it difficult to learn basic usage tips like how to properly replace line or adjust the brakes to stop backlashes.
After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending
After a day of fishing rinse each of your reels with fresh water and allow to dry. Don′t use a spray nozzle to do this however. High-pressure water can force sand dirt and salt into the reel. Use light pressure straight from the hose.
Spincast Reels: With these reels the line comes off the top of the spool while casting. The spool which runs parallel with the rod remains enclosed by a cover that features a port where the end of your fishing line exits the reel. The spool
Use tweezers to handle springs and wire clips. "That'll keep them from flying all over the place and maybe getting lost."
Clean parts with Simple Green. "Never use gasoline or similar products to remove dirt and grease from your reel's parts. It'll melt plastics. Use a biodegradable product such as Simple Green and a toothbrush that won't hurt the plastic or fiber parts of the reel."
Take your reel apart properly. "When you take your reel apart lay out the parts on a mat of some sort. Put a strip of masking tape under the line of parts and number each part as you remove it from the reel. That way
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.