Published at Saturday, April 07th 2018. by Rolande Yolande in Fishing Reels.
Spinning Reels: These devices are great for beginners or novice anglers. They are simple to use and mount on the underside of a spinning rod. The handle of a spinning reel is usually located on the left-hand side instead of the right. Spinning reels can handle smaller lures and baits They commonly offer an anti-reverse mechanism a simple design you can set by letting go of the bail arm after casting. This keeps your line from spooling off when you get a bite You may prefer a skirted spool in saltwater environments. These increase line capacity allowing longer casts and reducing tangles. They also protect the inside mechanisms of the spool from salt and moisture.
The drag system of your reel applies friction to the spool. This helps as you cast and while you are attempting to bait a fish particularly larger species. Older models traditionally have a fixed drag that cannot be adjusted spring and pawl drag systems for fly fishing offer some adjustment and have a distinct clicking sound when line is pulled off the reel disc drag systems provide the smoothest type of drag. They are used in many modern fly reels adjustable disc drags allow anglers to make fine adjustments to the level of drag pressure.
Degrease Stiff Reels. If you purchased a new fishing reel and found it a little stiff when casting take it apart and see if you need to remove some of the grease on the gears. Old reels work better too if you clean out gummed-up grease and replace it with a fresh coating of light lubricant. A solvent like Ardent Reel Kleen or isopropyl rubbing alcohol works great to loosen up all grease. A Q-Tip or soft cloth can be used for application.
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last longer in better condition.
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per bearing. Again use a toothpick."
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.