Published at Friday, April 06th 2018. by Kasumi Yuki in Fishing Reels.
To keep reels in prime fighting condition periodic disassembly and cleaning is necessary at least every two years preferably annually. Because of the intricate mechanics this chore is best left to professional technicians at reputable tackle shops or service centers. The reels will be completely disassembled down to the last screw and thoroughly cleaned with ultrasonic dunking the preferred method. For the quickest turnaround have this done in the winter off-season.
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
Spincast Reels: With these reels the line comes off the top of the spool while casting. The spool which runs parallel with the rod remains enclosed by a cover that features a port where the end of your fishing line exits the reel. The spool remains stationary until you use a thumb button to cast. As you release the button your bait or lure will propel your line. The ease of spincast reels makes them a good choice for novices. They′re reliable and lack complexity.
When you′re on a hot bite or a long-planned trip the worst thing that could happen is tackle failure. Losing a great catch due to something that could have been prevented is annoying. Avoid that problem by maintaining and regularly servicing your spinning reels and you′ll enjoy years of dependable use. Here are some steps to keep those reels in good working order.
There are three types of drag systems : 1. Spring and pawl or “click and pawl” systems feature a spring that pushes the prawl into a gear on the reel spool to produce a drag. Spring and pawl is best for light fishing when targeting panfish 2. Disc drag pushes a large-diameter pad against the reel spool′s braking surface. Pressure is applied directly to increase overall control and efficiency. Cork or synthetic materials like Teflon are used in disc drag systems. Cork provides a smoother more consistent pressure and can be easily adjusted. These systems are great for fighting large strong fish 3. Caliper drag systems fall between disc and spring and pawl. A caliper pad pushes against the braking surface of the spool. This friction slows the way the reel spool spins.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.