Published at Saturday, March 03rd 2018. by Rubina Sibilla in Fishing Reels.
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels can be maintained much the same as casting reels. Just remember the basics — stay organized clean properly grease gears and oil bearings.
If you′ll be stowing your rods and reels for a couple of months – in winter for example – strip the line and leave it off until just prior to your first trip of the new season. That way you′ll know you are starting with fresh line when you begin again.
After cleaning wipe the reel down with a rag soaked with a protective coating like Aluma Guard Reel magic or WD-40. A light coating of liquid furniture polish will also work. Be careful to avoid contact with the line or handle grips.
There are three types of drag systems : 1. Spring and pawl or “click and pawl” systems feature a spring that pushes the prawl into a gear on the reel spool to produce a drag. Spring and pawl is best for light fishing when targeting panfish 2. Disc drag pushes a large-diameter pad against the reel spool′s braking surface. Pressure is applied directly to increase overall control and efficiency. Cork or synthetic materials like Teflon are used in disc drag systems. Cork provides a smoother more consistent pressure and can be easily adjusted. These systems are great for fighting large strong fish 3. Caliper drag systems fall between disc and spring and pawl. A caliper pad pushes against the braking surface of the spool. This friction slows the way the reel spool spins.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.