Published at Monday, April 09th 2018. by Juliane Pia in Fishing Reels.
Egg Carton Parts Holder. If you′re the handyman type who can dismantle your own reel for maintenance here′s a tip you can use. Save an empty egg carton or three and number each compartment. Then when as you′re taking your reel apart place each part in a separate compartment of the egg carton(s) as you go along putting part 1 in compartment 1 part 2 in compartment 2 and so on. When reassembling the reel you can pick up the parts in reverse order and get everything back together right. Of course it′s also a good idea to save and file the schematics that come with the reels you buy and use them when you′re doing reel maintenance. That′s the best way to know what goes where.
Spincast Reels: With these reels the line comes off the top of the spool while casting. The spool which runs parallel with the rod remains enclosed by a cover that features a port where the end of your fishing line exits the reel. The spool remains stationary until you use a thumb button to cast. As you release the button your bait or lure will propel your line. The ease of spincast reels makes them a good choice for novices. They′re reliable and lack complexity.
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels can be maintained much the same as casting reels. Just remember the basics — stay organized clean properly grease gears and oil bearings.
Assemble the proper tools before you begin. "You'll need two small screwdrivers — a slot head and a Phillips — along with a pair of tweezers and an old toothbrush. If you have the wrench and parts list that came with your reel keep them handy too."
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.