Published at Saturday, March 10th 2018. by Rubina Sibilla in Fishing Reels.
Proper Lubrication. Proper reel maintenance includes lubricating all moving parts such as bearings spool spindles and gears. You should lubricate lightly however and do not use heavy oil or grease. These can gum up or leave a residue that can inhibit movement of the bearings and other close-tolerance parts. Fine light lubricants such as Rem Oil or Blakemore′s Reel Magic Lubricant are excellent choices. Despite advice you may get to the contrary do not use WD-40 or Vaseline to lubricate any of your reel parts. These work well for many applications but they′re not good for reels. Most manufacturers recommend that you re-lubricate your reel on at least a monthly basis – more often with heavy use. At the very least lubricate everything once during each season you′ll be fishing.
Each reel is a little bit different but the basics are the same. Here are the elementary steps the Kilpatricks recommend to keep your reel working properly.
Spinning Reels: These devices are great for beginners or novice anglers. They are simple to use and mount on the underside of a spinning rod. The handle of a spinning reel is usually located on the left-hand side instead of the right. Spinning reels can handle smaller lures and baits They commonly offer an anti-reverse mechanism a simple design you can set by letting go of the bail arm after casting. This keeps your line from spooling off when you get a bite You may prefer a skirted spool in saltwater environments. These increase line capacity allowing longer casts and reducing tangles. They also protect the inside mechanisms of the spool from salt and moisture.
Grease gears. "Apply grease to the bottom of the teeth not the top. Applying grease to the tops of the teeth will cause the gears to throw the grease everywhere. You want it in the bottom. Also don't slop the grease all over the place; a light coating is all you need. We apply it with a toothpick or a small brush."
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.