Published at Tuesday, April 10th 2018. by Evdokiya Lidiya in Fishing Reels.
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
Spinning Reels: These devices are great for beginners or novice anglers. They are simple to use and mount on the underside of a spinning rod. The handle of a spinning reel is usually located on the left-hand side instead of the right. Spinning reels can handle smaller lures and baits They commonly offer an anti-reverse mechanism a simple design you can set by letting go of the bail arm after casting. This keeps your line from spooling off when you get a bite You may prefer a skirted spool in saltwater environments. These increase line capacity allowing longer casts and reducing tangles. They also protect the inside mechanisms of the spool from salt and moisture.
Degrease Stiff Reels. If you purchased a new fishing reel and found it a little stiff when casting take it apart and see if you need to remove some of the grease on the gears. Old reels work better too if you clean out gummed-up grease and replace it with a fresh coating of light lubricant. A solvent like Ardent Reel Kleen or isopropyl rubbing alcohol works great to loosen up all grease. A Q-Tip or soft cloth can be used for application.
After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending on use; a shiny or worn one needs to be replaced immediately. Technicians also know whether to lube the drag washers. Certain drag material requires lubricants to work properly while others are designed to stay dry and grease-free. Keep your spinners spinning smoothly and they won′t let you down when that drag starts screaming.
After a day of fishing rinse each of your reels with fresh water and allow to dry. Don′t use a spray nozzle to do this however. High-pressure water can force sand dirt and salt into the reel. Use light pressure straight from the hose.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.