Published at Monday, April 09th 2018. by Kasumi Yuki in Fishing Reels.
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels can be maintained much the same as casting reels. Just remember the basics — stay organized clean properly grease gears and oil bearings.
Proper Brake Adjustment Equals Fewer Backlashes. You′ll make more accurate casts with fewer backlashes if you adjust your baitcasting reel′s mechanical brake according to the weight of the lure you′re casting. Look for the brake adjustment knob on the side-plate beneath the handle. With the lure attached to your line depress the free-spool button while lightly thumbing the line. When the brake knob is properly adjusted the lure should descend slowly to the ground and stop without any spool overrun. If the lure falls too quickly or slowly adjust the brake knob to compensate.
Some of my fishing buddies like me have invested a lot of money in the fishing reels they own. With few exceptions though these guys rarely treat their reels like the expensive finely tuned pieces of equipment they are.
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
Line Replacement. When should you replace old line with new? There′s no set answer to that question but certainly you′ll want to replace it after any long taxing encounter with a hard-fighting fish which can compromise the properties of the line. I also replace mine after extended fishing time in waters with lots of rocks snags and other debris that can cause nicks and abrasions. And of course it′s time for more line whenever the amount on the spool gets too small due to changing lures losing baits to snags cutting off line because of “twisties” and so forth.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.