Published at Saturday, January 13th 2018. by Rolande Yolande in Fishing Reels.
Remove or secure your fishing line before you remove the spool. "Either strip all the line off the spool or secure it with masking tape before you remove the spool from the reel. If you don't the line will get caught between the spool and the frame and make removal very difficult."
Fill Your Reel Just Right. When using a baitcasting reel filling the spool to 90 percent capacity is recommended. This optimizes casting performance. Too much line is likely to increase the chance of backlash while not enough limits casting distance. For spinning reels a good rule of thumb is to fill the spool until there′s at least 1/8 inch of room from the line to the edge of the spool lip. That will let you use the most line capacity without causing line to spring off the spool and form tangles. The 1/8-inch rule applies to spincast reels too but you′ll have to remove the reel′s front cover so you can check the amount of line on the spool.
Outside of situations like those just keep an eye on your line and change it out when it fades frays or doesn′t feel as supple as it was when new. Like maintaining a reel keeping good-quality fishing line on your reels is key to your success. Tatty line might land a panfish or small bass without problem only to break when you set the hook in that fish of a lifetime.
Never put metal against metal. "Never put metal to metal when working on your reel. All reel parts are designed metal to fiber. Remember that."
Use tweezers to handle springs and wire clips. "That'll keep them from flying all over the place and maybe getting lost."
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.