Published at Tuesday, April 10th 2018. by Kasumi Yuki in Fishing Reels.
Each reel is a little bit different but the basics are the same. Here are the elementary steps the Kilpatricks recommend to keep your reel working properly.
Assemble the proper tools before you begin. "You'll need two small screwdrivers — a slot head and a Phillips — along with a pair of tweezers and an old toothbrush. If you have the wrench and parts list that came with your reel keep them handy too."
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per bearing. Again use a toothpick."
Never put metal against metal. "Never put metal to metal when working on your reel. All reel parts are designed metal to fiber. Remember that."
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.