Published at Saturday, 07 April 2018. Fishing Reels. By Evdokiya Lidiya.
Fill Your Reel Just Right. When using a baitcasting reel filling the spool to 90 percent capacity is recommended. This optimizes casting performance. Too much line is likely to increase the chance of backlash while not enough limits casting distance. For spinning reels a good rule of thumb is to fill the spool until there′s at least 1/8 inch of room from the line to the edge of the spool lip. That will let you use the most line capacity without causing line to spring off the spool and form tangles. The 1/8-inch rule applies to spincast reels too but you′ll have to remove the reel′s front cover so you can check the amount of line on the spool.
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per bearing. Again use a toothpick."
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last longer in better condition.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.