Published at Tuesday, April 10th 2018. by Rolande Yolande in Fishing Reels.
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels can be maintained much the same as casting reels. Just remember the basics — stay organized clean properly grease gears and oil bearings.
Proper Lubrication. Proper reel maintenance includes lubricating all moving parts such as bearings spool spindles and gears. You should lubricate lightly however and do not use heavy oil or grease. These can gum up or leave a residue that can inhibit movement of the bearings and other close-tolerance parts. Fine light lubricants such as Rem Oil or Blakemore′s Reel Magic Lubricant are excellent choices. Despite advice you may get to the contrary do not use WD-40 or Vaseline to lubricate any of your reel parts. These work well for many applications but they′re not good for reels. Most manufacturers recommend that you re-lubricate your reel on at least a monthly basis – more often with heavy use. At the very least lubricate everything once during each season you′ll be fishing.
Proper Brake Adjustment Equals Fewer Backlashes. You′ll make more accurate casts with fewer backlashes if you adjust your baitcasting reel′s mechanical brake according to the weight of the lure you′re casting. Look for the brake adjustment knob on the side-plate beneath the handle. With the lure attached to your line depress the free-spool button while lightly thumbing the line. When the brake knob is properly adjusted the lure should descend slowly to the ground and stop without any spool overrun. If the lure falls too quickly or slowly adjust the brake knob to compensate.
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
Each reel is a little bit different but the basics are the same. Here are the elementary steps the Kilpatricks recommend to keep your reel working properly.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.