Published at Tuesday, April 10th 2018. by Kasumi Yuki in Fishing Reels.
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per bearing. Again use a toothpick."
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels can be maintained much the same as casting reels. Just remember the basics — stay organized clean properly grease gears and oil bearings.
Each reel is a little bit different but the basics are the same. Here are the elementary steps the Kilpatricks recommend to keep your reel working properly.
After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending on use; a shiny or worn one needs to be replaced immediately. Technicians also know whether to lube the drag washers. Certain drag material requires lubricants to work properly while others are designed to stay dry and grease-free. Keep your spinners spinning smoothly and they won′t let you down when that drag starts screaming.
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.