Published at Tuesday, April 10th 2018. by Rubina Sibilla in Fishing Reels.
To keep reels in prime fighting condition periodic disassembly and cleaning is necessary at least every two years preferably annually. Because of the intricate mechanics this chore is best left to professional technicians at reputable tackle shops or service centers. The reels will be completely disassembled down to the last screw and thoroughly cleaned with ultrasonic dunking the preferred method. For the quickest turnaround have this done in the winter off-season.
After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending on use; a shiny or worn one needs to be replaced immediately. Technicians also know whether to lube the drag washers. Certain drag material requires lubricants to work properly while others are designed to stay dry and grease-free. Keep your spinners spinning smoothly and they won′t let you down when that drag starts screaming.
Use tweezers to handle springs and wire clips. "That'll keep them from flying all over the place and maybe getting lost."
Fill Your Reel Just Right. When using a baitcasting reel filling the spool to 90 percent capacity is recommended. This optimizes casting performance. Too much line is likely to increase the chance of backlash while not enough limits casting distance. For spinning reels a good rule of thumb is to fill the spool until there′s at least 1/8 inch of room from the line to the edge of the spool lip. That will let you use the most line capacity without causing line to spring off the spool and form tangles. The 1/8-inch rule applies to spincast reels too but you′ll have to remove the reel′s front cover so you can check the amount of line on the spool.
After all that put your reel back together; check to make sure everything is working the way it should back the drag off and apply a little Reel Magic to the exterior to protect the finish and line. You'll be good to go. Spinning reels can be maintained much the same as casting reels. Just remember the basics — stay organized clean properly grease gears and oil bearings.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.