Published at Sunday, April 08th 2018. by Rubina Sibilla in Fishing Reels.
Take your reel apart properly. "When you take your reel apart lay out the parts on a mat of some sort. Put a strip of masking tape under the line of parts and number each part as you remove it from the reel. That way you'll be able to put everything back together without having parts leftover."
Spincast Reels: With these reels the line comes off the top of the spool while casting. The spool which runs parallel with the rod remains enclosed by a cover that features a port where the end of your fishing line exits the reel. The spool remains stationary until you use a thumb button to cast. As you release the button your bait or lure will propel your line. The ease of spincast reels makes them a good choice for novices. They′re reliable and lack complexity.
Start each trip with a thorough cleaning. Gently rinse each reel to remove salt particles. Don′t loosen the drags yet and don′t use a lot of water pressure either to prevent forcing salt and dirt into internal components. If possible wash reels with warm soapy fresh water to remove salt body oils blood and dirt. Remove the skirted spool (and drag knob if necessary) and clean the underside of the spool and the spindle area. Next rinse the entire reel again with a gentle spray and let them air dry or pat with a towel or chamois. Next loosen the drag knob to remove pressure so the washers don′t become compressed and warped.
Proper Brake Adjustment Equals Fewer Backlashes. You′ll make more accurate casts with fewer backlashes if you adjust your baitcasting reel′s mechanical brake according to the weight of the lure you′re casting. Look for the brake adjustment knob on the side-plate beneath the handle. With the lure attached to your line depress the free-spool button while lightly thumbing the line. When the brake knob is properly adjusted the lure should descend slowly to the ground and stop without any spool overrun. If the lure falls too quickly or slowly adjust the brake knob to compensate.
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per bearing. Again use a toothpick."
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.