Published at Saturday, April 07th 2018. by Kasumi Yuki in Fishing Reels.
Line Replacement. When should you replace old line with new? There′s no set answer to that question but certainly you′ll want to replace it after any long taxing encounter with a hard-fighting fish which can compromise the properties of the line. I also replace mine after extended fishing time in waters with lots of rocks snags and other debris that can cause nicks and abrasions. And of course it′s time for more line whenever the amount on the spool gets too small due to changing lures losing baits to snags cutting off line because of “twisties” and so forth.
Egg Carton Parts Holder. If you′re the handyman type who can dismantle your own reel for maintenance here′s a tip you can use. Save an empty egg carton or three and number each compartment. Then when as you′re taking your reel apart place each part in a separate compartment of the egg carton(s) as you go along putting part 1 in compartment 1 part 2 in compartment 2 and so on. When reassembling the reel you can pick up the parts in reverse order and get everything back together right. Of course it′s also a good idea to save and file the schematics that come with the reels you buy and use them when you′re doing reel maintenance. That′s the best way to know what goes where.
There are three types of drag systems : 1. Spring and pawl or “click and pawl” systems feature a spring that pushes the prawl into a gear on the reel spool to produce a drag. Spring and pawl is best for light fishing when targeting panfish 2. Disc drag pushes a large-diameter pad against the reel spool′s braking surface. Pressure is applied directly to increase overall control and efficiency. Cork or synthetic materials like Teflon are used in disc drag systems. Cork provides a smoother more consistent pressure and can be easily adjusted. These systems are great for fighting large strong fish 3. Caliper drag systems fall between disc and spring and pawl. A caliper pad pushes against the braking surface of the spool. This friction slows the way the reel spool spins.
Fill Your Reel Just Right. When using a baitcasting reel filling the spool to 90 percent capacity is recommended. This optimizes casting performance. Too much line is likely to increase the chance of backlash while not enough limits casting distance. For spinning reels a good rule of thumb is to fill the spool until there′s at least 1/8 inch of room from the line to the edge of the spool lip. That will let you use the most line capacity without causing line to spring off the spool and form tangles. The 1/8-inch rule applies to spincast reels too but you′ll have to remove the reel′s front cover so you can check the amount of line on the spool.
Grease gears. "Apply grease to the bottom of the teeth not the top. Applying grease to the tops of the teeth will cause the gears to throw the grease everywhere. You want it in the bottom. Also don't slop the grease all over the place; a light coating is all you need. We apply it with a toothpick or a small brush."
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.