Published at Monday, March 19th 2018. by Juliane Pia in Fishing Reels.
Use tweezers to handle springs and wire clips. "That'll keep them from flying all over the place and maybe getting lost."
There are three types of drag systems : 1. Spring and pawl or “click and pawl” systems feature a spring that pushes the prawl into a gear on the reel spool to produce a drag. Spring and pawl is best for light fishing when targeting panfish 2. Disc drag pushes a large-diameter pad against the reel spool′s braking surface. Pressure is applied directly to increase overall control and efficiency. Cork or synthetic materials like Teflon are used in disc drag systems. Cork provides a smoother more consistent pressure and can be easily adjusted. These systems are great for fighting large strong fish 3. Caliper drag systems fall between disc and spring and pawl. A caliper pad pushes against the braking surface of the spool. This friction slows the way the reel spool spins.
Outside of situations like those just keep an eye on your line and change it out when it fades frays or doesn′t feel as supple as it was when new. Like maintaining a reel keeping good-quality fishing line on your reels is key to your success. Tatty line might land a panfish or small bass without problem only to break when you set the hook in that fish of a lifetime.
Fill Your Reel Just Right. When using a baitcasting reel filling the spool to 90 percent capacity is recommended. This optimizes casting performance. Too much line is likely to increase the chance of backlash while not enough limits casting distance. For spinning reels a good rule of thumb is to fill the spool until there′s at least 1/8 inch of room from the line to the edge of the spool lip. That will let you use the most line capacity without causing line to spring off the spool and form tangles. The 1/8-inch rule applies to spincast reels too but you′ll have to remove the reel′s front cover so you can check the amount of line on the spool.
Loosen Drag for Storage. Between fishing trips store each reel with its drag loosened. If you leave the drag tightened the drag washers are compressed and you could end up with a jerky or ineffective drag. Reduced pressure on the drag washers helps them last longer in better condition.
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.