Published at Saturday, 07 April 2018. Fishing Reels. By Juliane Pia.
Before rinsing tighten down the drags especially on spinning reels. This will help keep water from seeping inside. Hold spinning reels upside down with the drag toward the ground when rinsing giving water even less of an opportunity to get inside the reel.
After cleaning components are inspected before reassembly. If a part won′t endure a complete season it needs to be replaced. Items subject to normal wear and tear like plastic drag knobs are checked for stress cracks. Drag washers typically last a couple of years depending on use; a shiny or worn one needs to be replaced immediately. Technicians also know whether to lube the drag washers. Certain drag material requires lubricants to work properly while others are designed to stay dry and grease-free. Keep your spinners spinning smoothly and they won′t let you down when that drag starts screaming.
Oil bearings. "Clean bearings with lighter fluid. That'll remove all the dirt and grunge from them. After they're cleaned make sure they spin. That's very important because it'll tell you they're clean. Oil them with TG's Rocket Fuel — medium viscosity — one drop per bearing. Again use a toothpick."
Any content, trademark’s, or other material that might be found on the simontonauto website that is not simontonauto’s property remains the copyright of its respective owner/s. In no way does simontonauto claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 simontonauto. All Rights Reserved.